Posted by fixerupper on September 15, 2017 at 08:00:25 from (100.42.94.143):
In Reply to: Needle-Scalers 101 posted by Lanse on September 15, 2017 at 06:49:12:
My advice is to just go ahead and use it. I have used mine extensively cleaning up several large projects, enough to go through one set of needles. The flared end of the needle will eventually break off and the needle drops out but it takes a lot of scaling to get to that point. There usually is no need to bear down hard on it, just easy pressure and it will do it's job. A needle scaler does not work on soft materials or grease, it just punches holes in it. Mine is a straight line scaler and if I use it for any length of time it helps to wear padded gloves so my hands don't get to buzzing from the vibes. Hearing protection is recommended.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
