Posted by W_B on September 13, 2017 at 10:48:13 from (155.188.123.20):
In Reply to: wire size posted by TexasCowboy on September 12, 2017 at 15:50:29:
Quoting Removed, click Modern View to see
Not really. You need the factory resistor (the one on the back side of the dash) to keep from melting the innards of the coil. Even with a 12V conversion using the 12V coil. If a 12V system and using a 6V coil you'll likely need the additional resistor to keep from melting the coil. I had the aftermarket ceramic resistor on my 6V 9N when the factory one went bad, and that is too much resistance and it was hard starting. There is a very good reason that old Henry put that resistor in there!
Go over the 9N, 2N, 8N page on this forum and the guys there will give you chapter and verse on resistors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Winterizin Engines - To Drain or Not to Drain? - by Staff. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "Winter is fast approaching..for a gas tractor should the gas tank be drained and run the engine til the carb is dry or do the gas stabilizer products I've heard of work? (tractor will not be used til spring) any other tips for winterizing?? "
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
