Raking hay would never have caused it to get hot enough to damage the trans with or without a cooler you had something else go wrong and cause your issue,, I will have to look over some early lit,, like 3pt remotes pto all were options I have seen and worked on hundreds of them here never seen one without a cooler,, but I know some dealers and people wanted to save every dime they could when buying new so I could see dealers order them without one, like 3pt we only sold one 30 series without it and we had to special order it in for the man, same way with 580 backhoes, every 580 we sold new from 580CK starting in 1966 through the 580C the last 580 model we sold before the dealership was sold had a dsl engine and powershuttle, and front counter weights, we had dealers from other places get a couple bids from us as they sold them a dry clutch 580 with nothing but bare bones equipment on them,, one even sold them a 580C with only ROPS when the bid clearly said a cabed unit,, I guess I find it odd they would even order one without the cooler as to me it was just something you always speced them with, we always tried to think ahead for some job they were going to use them for they had not thought of yet
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
