Posted by Bret4207 on September 07, 2017 at 05:40:18 from (64.19.90.196):
In Reply to: Poulan Saw Problem posted by rusty6 on September 04, 2017 at 20:29:33:
I believe it depends on where you live and the specific blends and what you are using it in. In a car or truck it makes no diff I've seen. In small engines, it can be a killer. You and I both have old saws. You put a 10% ethanol fuel mix in an old Pioneer and I can tell you that within 2 days you will need Channel Locks to get the plastic cap off. Then the fuel line will turn into a gummy worm a few days later. Change the fuel and the cap will return to more or less normal in a few weeks.
Anyone that hasn't had trouble with ethanol blends in small engines is lucky. Your luck doesn't mean the rest of us that have are fools or liars.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
