Posted by kcm.MN on August 24, 2017 at 15:23:10 from (174.219.131.170):
In Reply to: Adding Power (OT) posted by KEB In GCMS on August 24, 2017 at 14:47:52:
When you say "...using a couple of 110v outlets", it depends entirely on just what you plan to plug into those outlets. In other words, what do you figure will be the absolutely highest amount of amps drawn?
If you use a battery charger, what size? Is it a wheeled model with 200amp start capacity? Will you ever use a 100v welder? Maybe an air compressor and large angle grinder at the same time?
If you ONLY want the capacity of a single standard 110v outlet, then you can run 12-2 no problem. If you might need a little more capacity, go with 10-2. But if you plan on ever in your lifetime needing more than that, best idea would be to run your wiring in smooth-bore conduit and sized large enough that you could easily upgrade at a later time without having to dig up and re-bury things. Plastic conduit will also help protect the wiring from accidental memory loss (forgetting that there is wiring buried there) or from someone else who doesn't know it's there. You could also choose to run 10-3 with ground and be ready for 220v use, but leave one of the wires unused at this time. If you do this, label that wire on both ends so that any stranger can know why it isn't hooked up! Is also a good idea to cap and electrical tape each of those ends, again, for the benefit of an uninformed person.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I�m handing him tools and he says, "give me that..." and I�ve already got it in his hand or "hand me that....."and I�ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
