You should be able to order or source copper chromated arsenate .40 or higher pressure treated wood for ag and industrial purposes. The EPA did away with it for consumer/residential purposes and is why you can't get it "off the shelf" today. Very effective wood preservative, except at some point it was frowned upon for playgrounds, picnic tables etc. I think most would have an opinion to share as to its safe use, myself included.
If this is new material, then you likely have ACQ or whatever the current ground contact treated wood there is available. You should be able to leave it alone if you use the ground contact type. Ideally, install it and let it dry out in place, then use a wood preservative as needed or oil.
The thing is this wood is kiln dried southern yellow pine (at least out here its been this species for as long as I can recall) then it's put into a pressure vessel for preservative treatment. When it comes out it is high moisture. I have hauled more trailer loads of the old stuff than I can recall. Heavy, wet and curls up drastically if left out to dry in hot weather individually.
Like was said, applying oil works, but it must be like kiln dry to wick in properly. I'v done it in addition to creosote, it works well on posts in well drained soils. How you achieve that low moisture content and not have it warp is beyond me. If it does not wick in, you will have a guaranteed slick surface that is dangerous to walk on and or haul things on.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
