Posted by HVFDfirefighter on August 09, 2017 at 07:18:26 from (67.45.32.33):
I need to replace the touch control mounted temp gauge on my 52 Super A. I see they go for right around $70. I can get one for a Case (still has IH printed on the dial) for about $30. I can get a LIGHTED one for a Ford Jubilee for $20. Both have a metal casing to wrap wire. I can make the bracket that holds the gauge to look much like the original. My question is: are the probes/fitting all the same? I have not taken mine out of the tractor's block yet. The new ones look to have about 1 - 1.5 inch long probe and a 3/8' fitting. Wires are 33" longs. I also need to purchase two touch control stops. I see they are $13 each. the tabs are broken on two of mine. It does not look they can be welded. (Haven't checked, but they look to be a different kind of metal, maybe even cast).
Any help, thoughts, comments are is always appreciated
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
