Posted by philip d on August 08, 2017 at 18:07:12 from (142.68.126.16):
In Reply to: Re: Silage bunker??? posted by cumminspuller on August 08, 2017 at 14:53:03:
Anything designed for covering silage is good usually. We've had great luck with megaplast. Good plastics is usually white (outside) and black against the pile. Like others have said narrow depending how many animals your feeding. We're feeding 65 dairy cows half grass half corn. Our piles are 40' wide plastic and in summer we can barely keep ahead of heating. We go 2 dump truck widths at a time leaving a couple feet between the piles to start the pile and build it from there. Have to leave some leeway on your piles too. Ex. If your using a 40' wide cover keep measuring your pile as you go and stop adding to that section once it reaches 35-37' across including the sidewalls. Using bales as walls will end up in a lot of spoilage. Another thing we do if for whatever reason we're not going to start to finish a pile in 2 days well temporarily cover completed sections of a pile till it's finished. Extra work yes but big pay offs. You really have to treat it as round bale silage. You wouldn't bale silage today and leave it out to wrap in a weeks time or put the wrap on loose and expect it to keep well. All silage is the same,need all the air out and sealed quickly for good results. Im no expert but I've learned the hard way how not to do it. If you can cover it soon as it's done and if you use dirt start covering the edge along one side being careful not to pull the plastic than when you get to the other side pour the dirt that it slides down the sides and it will pull the plastic super snug. Keeping that air out is the key. Than the tires will keep it from flapping during windy days or when your feeding out of it. You can make ag bag silo quality silage with a pack pile IF it's covered very well and you will be very pleased. I've made poorly sealed piles in the past and I bet we had minimum 30% spoilage on the top and sides.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
