Posted by W_B on July 27, 2017 at 08:28:26 from (155.188.123.24):
In Reply to: Lean Tool? posted by indianabuckman on July 27, 2017 at 08:02:29:
I think you mean a lean-to. I did this on a metal sided barn at my other place. I nailed and bolted a 2x6 (or 2x8, can't remember the size) to the poles and girts, right through the metal, just under the eave of the barn then used joist hangers to put the joists for the lean-to on that piece, then metal roofing over that. It's still there after 20 years. The end attached to the barn is essentially covered so there's no rain getting in behind it and running down the wall.
I think if you are attaching it to an exposed area you'd have to cut the siding and so the attachment is behind and under the siding and probably need flashing to route water onto the lean-to roof. If attaching as an extension of the existing roof line I'd take any trim off, if the eaves are enclosed, or just extend the roof rafter, depending on how the roof is framed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
