Posted by kcm.MN on July 24, 2017 at 19:39:47 from (174.219.136.197):
In Reply to: Double Truck Frames posted by showcrop on July 24, 2017 at 16:50:44:
I've heard a couple of different things in the past about the reason for double frames. Besides when making repairs, it seems as though there was a time when manufacturers would use a double frame for a heavier-duty truck - like, a SA tractor might have a single frame, but a heavy haul rig would have the same frame doubled for extra strength. Sounds kinda weird to me, but then I think I learned that online......so you KNOW it must be the truth! 8)
The other thing is, that sometimes a truck with a particular purpose will need a doubled frame as all of its load is concentrated in a certain area, rather than being distributed over the entire frame. ...Only possible example I can think of offhand might be a dump truck, but I would tend to think they would have their own special frames.
If nothing else, just consider this post as "Junk Mail". :lol:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.