Well i can see a total tear down in your future , IMHO the only things that i would not take apart down to bare housings would be the hyd. cylinder , Yep that means Every thing else and when done making all sorts of parts piles and bare castings and housings then ya can start the cleaning and checking and putting the pieces and parts back together. Years back a new hire was sent out to a oil well drilling location with a new John Deere 750 dozer with 72 working hours on it to reclaim the location and i asked him if he knew how to SQUEEZE the pits as there were two working pits and one BIG blow pit and i got oh yea i know how to SQUEEZE PITS . Well the lowboy driver calls on the radio and tells me that he had dropped that 750 off at the location and was head on to the next move and it was not fifteen min. later when this new operator calls on the radio and say he is STUCK , not something that was not uncommon in the patch to stick a dozer, So that means i am going to have to hook up to the extra lowboy and load another dozer and drive the 30 miles to that location and drag him out . When i got there and drove back to the location first i could not find the dozer or the operator ( he went for coffee and left the location) and i get looking around for the dozer on a FLAT 250 x350 foot location , other then the dike of the blow pit That dike was maybe four foot tall and i drove over to the pit and setting in the middle of this PIT was the top of the ROPS and the top pipe off the muffler sticking up out of the water , Air intake is under water . With great effort and a second dozer we got it out and up on the lowboy and back to the shop and when done tearing it down only the frame work was in one big chunk .
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
