Posted by Butch(OH) on July 21, 2017 at 03:14:46 from (66.192.33.38):
In Reply to: Stihl ms290 question posted by Ralph46 on July 20, 2017 at 17:32:22:
A used saw is always a crap shoot for those who dont know saws well.The 290s were Stihl's most popular saw when they were made. They are the middle line between home owners saws and professional saws, The current model is MS291 and sells for right around $450 new. Seen a few good ones sell at auction lately and they bring $150-200. A few extra chains, oil,case fuel can etc (if thrown in) add up to many $$$ in extras. Without inspecting it and running it it's hard to say from this vantage point if that particular saw is a good buy or not. If toasted they are generally not worth rebuilding. Anything more than a simple tune up at a dealer adds up the $$ quickly. You can preform these tests. It should start easily, 3-5 pulls unless it has set forever. Take a chunk of wood along and make a few cuts to see if it maintains power an then goes back to idle OK. Then while idling put the chain brake on, it should not change speed or sound. Then with the chain brake STILL ON for safety, turn the saw sideways for a couple seconds (both sides), then upside down for a couple seconds then bar pointed down, then bar pointed up. If it changes speed or dies say no thank you because trouble is soon coming that will cost you lots when preformed at a dealer.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
