Posted by Bob on July 19, 2017 at 07:48:30 from (64.255.159.192):
In Reply to: JD 2010 Hydraulic posted by Heitkamp on July 19, 2017 at 06:25:59:
It's an open-center system so DO NOT simply cap the ports.
I'm not sure exactly how the 2010 was adapted for "power beyond"... It MAY be as simply as connecting the two ports with a length of hose, possibly an internal passage MAY have to have a plug removed, or it's possible the end plate for the hydraulic valve(s) will need to be changed. Also, there's at least one serial number break that affects lots of things in the hydraulic valve area.
I have an operator's manual, but I doubt that covers it, I'll look.
A factory shop manual, or possibly a manual for the loader would probably be the best sources of accurate info. (ebay, perhaps?)
WHATEVER you do, DO NOT proceed without knowing for sure what needs to be done, that is not one of the most robust hydraulic systems ever made, and some parts may be hard to get, so you don't want to mess anything up!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
