Posted by Steve@Advance on July 15, 2017 at 08:09:25 from (66.169.147.211):
In Reply to: Chinese ATV posted by JDEM on July 15, 2017 at 05:43:48:
I would be very afraid of it. Chances are it would fail quickly and be unrepairable.
I'm surprised you were satisfied with the kids ATV. My boss bought one for his grand kids, it was a total piece of junk! As you said, the bolts fell out! Some because it appears to have been dealer assembled by idiots, but also because of poorly welded weldnuts, misaligned holes, poor design all around. But the worst part is the drive ability. It has an internal centrifugal clutch. Rev the motor, nothing happens, then suddenly it launches! Then when it comes to a stop, the engine dies, like the clutch is slow to release. The worst case for inexperienced kids to be handling!
Plus, he was lied to. Told it was a Polaris clone, everything was the same, same engine, all parts will interchange... Nothing is even close!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
