Posted by pat sublett on July 12, 2017 at 16:51:24 from (108.206.187.167):
I had a well drilled this morning. there are no other wells in my area but I thought I would gamble. Water rates prohibit even watering my trees. Drilling rig used airpressure to remove the material and sombody called the fire dept because of the dust blowing off the dry shale. I was looking for shallow water because I know there is no deep water so I stopped him at 100 foot, no moisture at all just dry shale at 100 ft. Driller pulled out, I told him I would fill the hole. I went to the house and ate lunch. Went back to fill it after lunch and I heard water splash, waited awhile and I heard something else fall into water. I got a 100 ft cord and tied a plastic bottle on it, dropped it in the well and pulled up a cup full of gray water. I then got an 8ft 2x2 board, tied it on the cord and let it down. I thought I could see how far the water came up on the stick. I tied a knot in the cord a 100 ft. When I pulled the stick up the whole board was wet plus 50ft of the cord. I ordered a $100 dolar submergable pump and thought I would see how much water I could pump. Any advise. I am hoping the well don't cave in before I can determine if it is worth fooling with. Any Advise?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
