Posted by farmer boy on June 29, 2017 at 16:58:57 from (199.33.94.48):
In Reply to: Lock tight, or grease ? posted by Bruce from Can. on June 29, 2017 at 08:02:04:
I wouldn't put grease on those bolts, but have put fluid film on them before. It's common enough for loader frame bolts to work loose. If it was 2 flat surfaces bolted together, the paint HAS TO BE REMOVED. The work order should have that noted on it. If it doesn't, I would ask that the frames are removed and cleaned up. Depending on the touch up job after removing the paint, you may be able to see if the paint has been removed. Maybe Kubota doesn't do it, but I know Case IH Puma use what I'll call a taper lock system. There's 4 cones on the tractor sub frame, and the loader sub frame has 4 taper bored holes that match up. Less paint to clean, and a better mount in my opinion.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
