Posted by Texasmark1 on June 29, 2017 at 05:32:28 from (99.197.190.172):
In Reply to: drum mower posted by merlynr on June 28, 2017 at 14:22:15:
If you are talking about the Galfre 190 like I have it comes from Turkey. Nice machine, no problems with mine. I did install a hyd cylinder to replace the far end rod so that I could not only lift it vertically, I could then tilt the outside end up in the air (like you see disc mowers carried) for transport.
Blades run me $25 per hundred, two sided, tempered and coated steel. Being 2 sided, you can run them and when dull swap to the other drum and run the other side of the blade. I run 6 per drum and before a cutting I take my hand grinder and tune them up...no need to put in a new blade when the existing one just needs a tune up....just takes a few minutes and you get a superb cut. It rides on the ground and has +/- ground variance capabilities.
I have the 1" spacer installed and on sudan-sorghum get about a 3" CONSISTENT stubble, unlike my JD 1209 swathers that who knows what your stubble length will be.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
