I didn't say the hardwoods were covered under the standards, so not sure why you should advise they aren't. Never said they were. I said they are unbelievably strong. If you care to debate that, I guess we can have your opinion on the strength of an actual 2"x4" piece of Hickory or oak.
As for the softwoods, if you are saying that they shrink 1/2 inch on the long side, care to make a wager? I will cut ANY softwood sopping wet at exact 4" on an 8' length and then kiln dry it. I guarantee it will not shrink down to 3.5". I don't care how long the standards have been around. If I go to my retailer, and I see a sign over boards that says: "2x4" I KNOW it's not 2 inches by 4 inches dimension. It is some significant fraction smaller because the mill decided to short me(literally) so they could increase profit. All I'm asking for is to call a spade a spade, and not a hoe.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
