Posted by LAA on June 24, 2017 at 22:49:03 from (130.117.142.131):
In Reply to: Re: Case 350 doser posted by Matthewa on June 24, 2017 at 12:47:02:
If it is a Case 350 diesel it will be a mid to late 70's model and it is comparable in size and power to a JD 350. I remember a lot of them used in the log woods years ago, operators liked them because they steer easy and the controls are conveniently mounted and they were also easy to work on and service. The winches I am familiar with were hydraulic, they had 3 position valves mounted on the operators platform to the right of the operator, the functions were simple, a brake position for hauling the load after it had been winched up, detent, or nuetral position for unspooling and of course the winching position. I can remember the 3 way valves sticking or by- passing and winch would be hard to spool off by hand, many times it would have to be pulled off by tieing to a tree but that was minor stuff and the valves were simple and cheap to rebuild. If the machine has been sitting any length of time you can just about count on the winch being somewhat tight but it should loosen up with use. I doubt I would pay 7500 for a 350, not because of anything wrong with one just more because the size of the machine limits what it can do, although if you take your time you could probably do a whole lot more with it than is commonly thought.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
