Posted by Andy Martin on June 18, 2017 at 19:07:37 from (209.213.149.120):
In Reply to: Too Much HP For Baler? posted by Bryce Frazier on June 18, 2017 at 17:42:34:
A Super M is just a good size for a NH68. Like others have said, you need to be able to engage the clutch slowly to get the baler moving. I never square bale with a live PTO, so when you get the baler plugged you should be able to ease the plunger into the bale to cut the plug over several tries without busting a shear pin. Starting with an empty bale chamber won't be the issue, it's starting after you've plugged it and are trying to restart it. I prefer an M over an H just for that reason. You'll be able to bale larger windrows with the M.
You won't wear out the NH68. You'll just have to replace wear parts and keep the knives sharp. The biggest load on a square baler is a combination of dull knives and a loose plunger.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
