My state has tougher wetland rules than the federal ones, so we get to go through 3 different offices to get permits, two federal and a state one. Actually the Feds pulled the state back a little a couple years ago, the state people took it upon themselves to be wetland gods and were overreaching even by their own rules.....
On general of you got tile in the field and grew crops on it before 1986 you can continue to do so, but can't touch anything that wasn't.
Now our govenor, who was too inept to run his family's Target stores, has decided that in his last 3 years in office he knows how to farm better than anyone else in the state and is bent on wrecking any farm in the state by giving all the the farm land to his hunting buddies.
So we are tiling as fast as we can before he completely stops us from farming.
Funny how there is such an outcry that ethanol supposedly takes food away from people; but the govenor can steal 125,000-300,000 acres of farmland for more hunting and all the city folk cheer.......
Anyhow.
The Devils Lake area of North Dakota is like you mention, water levels have risen there for a decade or more, it's really something how the water has risen there. There could be solutions to the problems there, but no, no, supposed to,let nature take its course and flood farmers and a couple small towns there, the natural water is more important than those hicks.
On the other hand, Fargo is spending billions of dollars to change the flow of the Red River to save their riverfront views from the high dollar areas of town.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
