Posted by Destroked 450 on June 08, 2017 at 06:48:16 from (173.242.142.14):
In Reply to: hay hay anfd hay posted by bg/mo on June 07, 2017 at 10:51:14:
Cut and rolled 38 acres week before last, good weather and everything went well but didn't make as much hay as last year.
Came a heavy 3 inch rain as I was leaving the field (luckily in a cab tractor).
Cut and tedded another 44 acres last monday, fields where wet from the heavy rain over the weekend and more rain was forecast by the end of the week, got a surprise 3/10" rain tuesday morning and had to reted everything again, after retedding again wednesday we were able to get some raked and started baling late that afternoon but evening moisture stopped us with only 45 rolls made, thursday after tedding out the unraked windrows due to ground moisture we got all of the hay raked and another 150 rolls baled, friday we flipped the windrows over and gave them a couple hours to dry before finishing up the rest of the field, it was a long week and even though the hay dried and was in good condition the tires on the tractor and baler stayed wet because of the ground moisture.
Finished cutting 12 acres last evening and plan to finish cutting the last 35 acres today.
A guy down the road offered me another 10-15 acres this morning for free if I'd cut it, it's about 15 miles away and normally I don't travel that far, but with everything we've cut so far coming up short of last year I'm going to look at it tomorrow.
We've had a very wet spring like last year but we had a very dry fall and feed hay during Sept and Oct, finished feeding in Apr with only 35 rolls left of the 950 I had rolled up last year. Normally we only need around 800 rolls but I'd like to have some extra in case pastures dry up again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
