Posted by Destroked 450 on June 06, 2017 at 08:30:18 from (173.242.142.14):
In Reply to: Long days... posted by kyhayman on June 05, 2017 at 13:56:40:
I'm between Louisville and Owensboro off of US60, we fought wet weather all last week starting with 3 inches of rain on Sunday and another 3/10 Tuesday morning after we had put down 44 acres Monday.
Tedded it 3 times and raked twice to get it dried up enough to finish baling Friday.
Rained yesterday morning and a hard rain last night, need to replace a bearing in the tedder and put the panels back on one mower where we had to replace a hydraulic line.
May try to cut some this afternoon, 83 acres done, another 40-60 to got depending if I take that last job I was offered of around 20 acres of native prairie grass. About 15 miles away on a farm I've never been on so we'll have to look it over first.
I bale with a 6610 series II cab tractor and NH BR7070 baler, mow with 4000 and 5000 Fords, the 4000SU I normally use for tedding and raking is down with a broken crank so I'm using my old Ford 801 diesel select o speed this year that normally only goes to shows and on antique tractor drives as a unrestored original, figured it needed a little more exercise this year.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
