Posted by Ultradog MN on June 05, 2017 at 03:26:12 from (172.58.86.185):
A few miles south of the Isle of Wight a huge Allied armada waits. 5000 ships and craft of all types and sizes, filled with 154,000 troops, it lies like a coiled spring. Waiting. Waiting for the weather to clear. Waiting for Ike to say the word that will launch the largest amphibious assault in history. The men onboard are cold and bored and seasick. And disappointed. They were supposed to have gone today. For us, looking back, an extra 24 hours of wait time doesn't seem like a big deal. We don't feel the ennui, nor the storm, the wet, the cold, the heaving of the vessel or smell the puke as our comrades lose it over the side. How many times can you check you gear? Sharpen your knife or strip your weapon? War is a dull business for them right now. And they have no idea when they'll go. If at all. But now we know... That in a matter of hours the coiled spring will leap into action. And the British Pathfinders will jump and the US 101st and 82nd will step out into thin air or board their gliders. And all those ships carrying the Canadians and Americans,the Brits, Free French and a bunch of Poles will finally point their bows toward the beaches code named Sword, Omaha, Utah, Juno and Gold. D Day is tomorrow. I hope that we never get bored, like the troops and sailors and airmen are right now and forget what an unimaginably huge event this was. Thanks
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.