The back of the feed chamber on a 273 is adjustable. If your plunger knives are dull they will fold over the uncut hay which adds more hay to the knife side. The easiest adjustment is to loosen the big bolt on the connecting arm (with the big coil spring) that is connected to the plunger and the feed rack. There is an adjustment bolt (after you loosen the big bolt) on the bottom side of that big bolt. Its usually rusted good from nonuse but it doesnt "hold" anything if you break it. You can adjust it so it will move hay lesser or further into the bale chamber. Also if its an old baler with rusted out bottom runs it will actually "hold" more hay into the bottom of the bale. Sometimes the way you feed it will make a difference in bale length. Tighten your chains also. With a manual you can pretty much figure anything out on it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
