Posted by Jim Naden on May 07, 2017 at 17:52:43 from (70.198.69.68):
In Reply to: 7130 3 pt need help posted by tjiniowa on May 06, 2017 at 21:13:48:
Quoting Removed, click Modern View to see
No.The controller is looking to match the hitch position potentiometer signal reading to the desired setting from the position control potentiometer. Disconnecting either sensor will default the system to a halt condition.
As Pete 23 already mentioned the position sensor on the rockshaft will often freeze up and slip the lever out of position. The danger with your situation is if you raise the hitch full up and the internal arm is pressing against the cover it can flex and break the casting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Little "M" - by Donnie Anderson. They call me "Little M" and this is my story. For the past several years I have sat against the tree-line, where my parts have rusted and rotted away. For all of these years I have wondered just exactly what happens to old tractors? Times were not always like this. I can remember back to 1948 when I was a brand new John Deere Model M. A man and his wife came to the dealer and looked me over real good. After many talks with the salesman a deal was struck and I, along with a M2 plow, c
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
