Posted by Leroy on May 02, 2017 at 05:32:57 from (69.88.204.212):
In Reply to: Grinding Pig Feed posted by Fullers Farmalls on May 01, 2017 at 18:13:09:
Do you have any access to any hay? If you do get some and run it in that mill and mix it in that hog feed. Better than buying the vitamins and minerals but you still do need some minerals and salt mixed in. And any size screen will work but the larger the holes the better. We had dairy as well as the hogs. So when we were baling hay all the chaff that aculmiated from putting the hay in we ground and put in the hog feed. There was a company a few miles from us that made what was called alfalfa meal and sold in 50@ bags at the elevator. We bought that for quite a while before we got our own mill. Now the chaff that came from handling the bales was mostly from the leaves and is the best part of the hay plant. The mill bought all the junk hay that nobody wanted to feed and mixed it with top quality hay to get a certain level of proteen. We never had our meal tested but am sure it had a feed value of at least 3 times the boughten feed as it came from the best part of good hay. Hogs do need what is in hay to do good and if they have access to hay in field they will eat it same as a cow or horse will. If you can do that your pigs will be healthier and grow faster. And a 10" mill will do it as that is what we had. Does not have to be a roughige mill. 800# corn to 200# oats plus 100# hay chaff ground. The pigs will love it. I think it possibly has been as long since we had livestalk as your Dad is old.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
