Posted by MikeinKy on May 01, 2017 at 17:45:14 from (184.45.46.84):
In Reply to: Re: disk size posted by Leroy on May 01, 2017 at 16:45:25:
I was replying to the post about the 3020 being as large as a 80. Back when the 3020 was almost new, my neighbor bought one with a 4-14 plow and another neighbor had a 730 and the 730 would out pull the 3020 in our hard clay ground. I was comparing my 820 with my 4020 last year on the same disk and the 4020 had the horsepower advantage, but didn't have the traction. The 820 would pull better with a drawbar load. Around here a 4020 isn't enough for 5-16's. 4-16's is a better fit. Some tried to pull 4-14's with 3020's but it was a struggle. I used to pull 5-14's with a 4020 and it was all it wanted. I didn't intend to step on anyone's toes. I was just telling of my past experience. I am 65 years old, so I have been around these tractors a long time. I have 2 4020's now.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
