I'll pass a long my experience. I can't run more than 25 head on a quarter section in Oklahoma so my herd sizes are about what you are looking at initially.
When I started in 1985 I built a steel alley to feed a Priefert squeeze chute and head gate. It worked well. Then I bought a Priefert sweep and a cheap head gate to put on another farm. I like the head gate better but I didn't like the sweep. The cattle balk because they can see everything that's going on.
Third place I set up a cheap head gate and just a panel pen. Fourth place I just set panels. Same with fifth place.
Now it's been a few years and I rarely use a head gate. I sold the sweep for $1,200. I like having a head gate for occasional needs but haven't had the need for a squeeze chute. I do have an iron corral and we can pin a cow behind a gate and do whatever we want without having to get her down the alley.
Just my experience. And I'm now back down to 20 head on my home place.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
