Posted by Steve@Advance on April 10, 2017 at 14:50:25 from (24.182.105.179):
In Reply to: Carburetor problem posted by fkelly on April 10, 2017 at 14:25:53:
There is a drain plug in the bottom of the carb. With the fuel valve on, remove the plug, be ready to catch what comes out in a clean glass.
It should have a full flow, then slow as the bowl empties, but still maintain a stream, not a drip or stop.
If not flowing well out the plug, fuel is not making it to the carb bowl. Could be the float level set too high, some have a screen in the elbow where the fuel line attaches to the carb, be sure the tank is vented, the separator bowl screen is in place and clean, the line should be steel, not copper, routed the most direct down hill path, as far from the exhaust as possible. If an inline filter is used, it needs to be a screen type, made for gravity systems.
If flowing well, revisit the carb. Look at what came out of the bowl. If rusty flakes, dirt, water are present, that is getting in the carb. Could be clogged again or contaminated with water.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
