Posted by nrowles on April 08, 2017 at 08:18:41 from (71.251.155.138):
I have anywhere from 1/2 acre to a few acres (depends on how I go about it and how energetic I get) of young pulpwood jack pine that I want removed from my property. Anywhere from 1"-12" but the average I would say is 4". I see a couple different options. My ultimate inquiry here is related to #4 below and what's after it.
#1 - Pay a crew $1,000 to chip the cut trees.
#2 - Pay an excavator $1,000 to push them in a pile and burn them. I don't really want to do this as it is a gigantic amount of material, would be a huge fire, and it is in a confined space.
#3 - Rent a chipper and get 6 guys to help me bust hump for a few days. Don't really want to bother a bunch of buddies.
#4 - Buy a used $3,000 chipper (that will take 6"-8" logs) and work at it myself over time. I would then sell the chipper when I'm done, hopefully for what I paid for it. I wouldn't want to buy a new one because when I go to sell it I will get much less for it and I might as well had just paid somebody else to do it.
What do you guys think about the situation, and specifically #4? I'm really hesitant to do this because I foresee a lot of headaches with buying a used $3,000 chipper. Are chippers like this bulletproof or should I expect repairs on putting a couple thousand trees through it?
I am somewhat impatient as well which I wish I were not.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
