Posted by Dave H (MI) on March 31, 2017 at 09:23:03 from (50.108.90.136):
In Reply to: OT : OT Discussions posted by NY 986 on March 31, 2017 at 05:59:31:
I agree with what I think you are saying. If I have an IH question, I put it on the IH board. Most other posts, OT or not, I put here. They can call Tales an "OT" forum, and when they brought it up from the basement the name was changed to reflect that, but Tales really did not used to fall into that category. Back in the day, Tales tended to have a small group of regulars with a larger group of people who dropped in and read but rarely posted (lurkers). People who dropped down from Talk were not always well received. And that is as far as I am going to go on that, because it seems to irritate some folk. I like the informational OT posts on this forum. I like general topic OT posts on here. I look at Talk kind of like a coffee shop. A group gets together, some talk about tractors, some about health, taxes, retirement, weather, gardening. People gravitate to the thread that interests them. Everyone has something to say. Nice place the way it is...IMHO. :)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
