A commercial livestock outfit needs a manure management plan in place before they spread. An analysis needs to be done and grid sampling needs to be done and proven and manure can be spread using VRT going by the results of the gridding. Grid sampling is required so the soil doesn't build up too much P&K. Farms around here that use only manure for fertilizer have the best yields year after year. There is no denying consistency is harder to obtain with manure, especially solid manure. Some feed yards are composting manure to get better consistency and first year availability to the crops. I have been using composted cattle manure on most of my acres but I haven't used it long enough to tell if it's good or bad. I "have been told" it's good stuff. The jury is still out. A local 5,000,000 bird egg laying outfit close to me composts all of the manure inside of buildings. When they first started this the manure was too chunky and inconsistent but they have been working on getting it better by mixing corn stalks or old hay with the manure to loosen it up. I have not used their composted manure because they think it is gold. We have tons of turkey manure used in this area and the guys really like it but I haven't used any myself to made a judgment on it. In the fall when the turkey manure is being spread everyone for miles around knows it by the smell but the smell doesn't last long.
So, yes manure is more inconsistent, but there is no negative talk about the usefulness of manure as fertilizer in this area after many years of manure used as fertilizer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
