Posted by Angle Iron on March 23, 2017 at 06:05:44 from (73.131.52.171):
In Reply to: Home heat pump posted by sandel on March 21, 2017 at 19:58:15:
Quoting Removed, click Modern View to seeMore than likely you have a variable speed indoor fan motor and they do start slow and ramp up over a brief start time. You may also have a unit that is a two stage as in the compressor or compressors change in capacity as the need changes. Trane used a twin compressor system where as capacity needs changed as in indoor and out door temps the compressors changed. If I recall one shut down and the other took over. Carrier on the other hand used the same compressor that reversed direction to go from the lower to higher capacity. The beauty in this type set up is it allows a higher capacity unit to be installed in a cooling setting giving added cooling for the occasional large gathering in your home. It also gives a larger unit for heat as the out door temps fall so does the btu output of a heat pump. The last data I read if I recall stated a 36,000 btu heat pump was only able to produce at about 24,000 btu range at 27 degree out door temps. The lower the outdoor temp the less btu's generated. They pick up heat from the out door temp and transfer it indoors. Systems are generally designed and sized more on the AC side with the heat relying on an alternate heat source to make up the difference. This is in reference to air to air systems. The water source units on the other hand at least the ones I have seen have no alternate heat source as they remain able to produce at rated capacity regardless of out door temps. That is based on an open well system that has a dead stable water temp. If closed loop wells or a trenched based surface closed loop system is used that loop temp changes as the season progresses. The longer and colder the season the cooler the loop temps. The reverse is true of the heating cycle. It in reality banks the heat or cold in the surrounding material. You start the heating cycle with warmer loop temps and as the colder temps come the cooler the loop becomes. Same in reverse for cooling. These swings are not huge but do take place. The cost of larger or more loops keep them at the absolute minimum average need. I believe its a false economy type reasoning. Heat pumps have come a long way from 40 years ago and are used in northern temps not workable then. Having said all that I still prefer gas heat and the unit we gave has a variable speed fan that is very quiet, rarely hear it come on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.