Posted by kcm.MN on March 23, 2017 at 03:44:31 from (174.219.129.233):
In Reply to: 3 pt. Fork lift posted by chris english on March 23, 2017 at 02:55:27:
Sorry, I don't do Facebook. How many lifting cylinders, their piston area, and the pressure of your system will tell how much the attachment can lift. If you have an older tractor, you probably won't come near maxing it out (remember, I can't see the thing), but if you have newer high-pressure hydraulics, then you'll need to know the max. working pressure of the weakest part of the system, be it the hose(s), pump, or cylinders. Check the fittings as well just to make sure some yahoo didn't replace a fitting with a plumbing-type (black pipe or galv.) fitting as they are not rated for hydraulic pressures.
Cylinder Force (lbs.) = Piston Area (sq. inches) x System Pressure (PSI)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.