Posted by fixerupper on March 21, 2017 at 09:01:23 from (100.42.94.143):
In Reply to: Metal Roofs posted by showcrop on March 21, 2017 at 05:42:54:
Any barn type steel roof with exposed screws has a chance of leaking. Every one of those hundreds or even thousands of neoprene gaskets is a leak possibility. One small kink in a seam might let water get through the seam. Any screw tightened too tight on a seam ridge might buckle the seam just enough to create a leak. Every building on my farm has a steel roof so ai am well aware of the leak possibilities from a steel roof.
The house roof has steel put on with screws but I put it over shingles with 2X4 furring strips so the shingles underneath catch any drip that might come from the steel. My latest project was a cattle shed I converted into a heated shop. The old galvanized steel roof had a few drips, not good when attic insulation is below it so I nailed down 2X4 furring strips on top of the old galvanized steel and screwed down regular barn steel roofing on the furring strips. The old steel might catch the few drips from the new steel and I am hoping the two layers with a 1 1/2 ' gap between the two will suppress condensation. My old shop, built in 1982, is pole construction with steel roof and side walls. The gray blown in insulation is now matted down from condensation drip from the steel roof and a few rain leaks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
