In the old tractor world there are basically 2 types of coils.
One is for use in 6 volt systems and has about 1.5 ohms resistance across the + and - primary winding. This coil may also be labeled "12 volt external resistor required" and needs a resistor between switch and coil input with resistance approximately equal to the 1.5 ohms of the coil when used in a 12 volt system.
The second type is a direct 12 volt coil (no resistor required) and has approximately 3 ohms primary resistance.
"so what u are saying is that the newer after market coils already break down the voltage to 6 for the dist" Has nothing to do with "newer after market coils". The distributor, points, and condenser do not care if system is 6 or 12 volts. The concern is limiting the current through the coil to about 4 amps max.
The difference in the two coils is the type of wire and/or number of turns used to wind the primary. There is no separate resistor in the coil case. It is the same difference as a 120 volt or 240 volt transformer used in household air conditioning or appliances. A transformer can be designed to work on 120 or 240 and give the same output voltage.
A tractor coil is a transformer with one side of primary and one side of secondary tied together.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
