Posted by NoNewParts on February 28, 2017 at 05:28:10 from (72.230.145.215):
In Reply to: Battery Terminals posted by John M on February 28, 2017 at 04:12:06:
if you have to use one.......
Like said, grease it up with whatever you prefer.
make sure you get the bare cable in there far enough...
make sure the bare cable end isn't too small for the clamp..if the clamp bottoms out too early, it ain't holding anything.
I turn that little clamp plate upside down, makes it harder to get everything assembled, but it will squeeze much harder.
Those little cable clamp bolts gotta be tight....like one more ounce of pressure will break/strip it tight..
most important...using one, you have changed the cable from an install and forget it part..into a maintenance item, check, clean, and tighten regularly.
and lastly.....throw a 7/16 wrench in the glove compartment or toolbox :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
