Posted by hotrodrail on February 25, 2017 at 12:43:25 from (71.185.49.176):
Hello, I am a new member looking for advise on the repair of an old Ross steering box, I cant seem to find any rebuilding info on the internet that is not related to tractors or military ross box's so after reading some of the posts on this forum I decided to join and ask my question hoping one of you can steer me in the right dirtection?
I have a box that was from a 48-49 crosley car but i was told it was also used on combines and tractors as well? the box works but it has a few spots when turning it that feel clunky/binding? I took it apart & found that the upper & lower bearings on the worm gear seem to be missing some balls, unless they are not supposed to have every space occupied by ball bearings? if you count the existing balls & empty spaces it looks like it takes 11 5/16" balls I have 9 on the bottom and 10 on the top. alot of the balls are pitted & rusted but still round. the race area is fine, no scoring or gouges and polish's up fine. the cups for the balls also look fine? the worm gear seems intact and smooth (not chipped or gouged) & following pin (steering arm) also looks fine?
so my question is , how many balls should be in the cups? I want to buy new ball bearings and reassemble the unit. I tried to put 11 balls around the cup and they dont fit? Is one ball smaller then the other 10? I will ad pic's of the gear & bearings that I took after removal & clean up and one pic of the bearing with 11 balls (that dont fit)
my second question is, would the pitted & rusted and missing balls cause the box to feel like it was binding or clunky in spots?
I appreciate any and all help I could get from you guys as there doesn't seem to be a crosley forum or related crosley "ross" steering rebuild thread anywhere on the net.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of David Brown - by Samuel Kennedy. I was born in 1950 and reared on my family�s 100 acre farm. It was a fairly typical Northern Ireland farm where the main enterprise was dairying but some pigs, poultry and sheep were also kept. Potatoes were grown for sale and oats were grown to be used for cattle and horse feeding. Up to about 1958 the dairy cows were fed hay with some turnips and after that grass silage was the main winter feed. That same year was the last in which flax was grown on the farm. Flax provided the fibre which w
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
