Posted by Texasmark1 on February 16, 2017 at 05:43:16 from (162.72.56.102):
In Reply to: Re: Chinese Junk! posted by Ozlander on February 15, 2017 at 16:19:06:
Not exact, but related. I have purchased bearings for my round baler rollers from China under the Seiko brand.....yes the Japanese watch mfgr. brand. As fine a quality product as you would ever care to put in your hand. A lot of suppliers have 3 listings for their parts, each with a different price and country of origin listed. Pick for yourself. So designers of equipment do just that.
As I have said before it's called "designed to cost". A Ford pinto was designed to cost what the low end buyer could afford. If the manufacturing of the product met the spec. and the spec. was of industry standard quality, it passed the test.
A Caddillac Sedan De Ville was designed for the other end of the market. Same applies.
If you get a low end mfgr. that builds sub standard parts that don't meet the intended specs, doesn't matter where they come from.....they are junk!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
