|
Tractor Talk Discussion Board |
Re: Operating a 24v device in a standard 24v truck
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by KEB on June 10, 2007 at 11:34:58 from (72.19.170.5):
In Reply to: Operating a 24v device in a standard 24v truck posted by David Voelkert on June 10, 2007 at 10:40:57:
First off, the two batteries in your truck are in parallel, which gives you 12 volts at twice the capacity, essentially the same as having a battery twice as big. In order to get 24 volts, you'd need some sort of a switch arrangement to put the third battery in parallel with the first two for charging and then in series with the normal 12 volt wiring to make 24 volts. You can't have 24 volts and charge the extra battery at the same time without some relatively fancy electronics. Assuming the lift runs on 24 volts and therefore requires some significant current, the easiest way would be to add a 24 volt alternator to the engine and two 12 volt batteries in series. This second system would be completely independent of the vehicles normal electrical system. If you don't use the lift a lot and can stand a slow charge rate, a simple kluge approach might be to use one of these cheap 120 volt interters to run a 24 volt battery charger to keep a second set of batteries charged. You'd want some sort of a relay on the input to the inverter so you don't leave it running when the engine isn't on and run down your starting batteries. You might also do a search & see if you can find a 12 to 24 volt converter that could be used to charge the second set of batteries. I've never seen one, but that doesn't mean they don't exist. Keith
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|