Posted by dieseltech on February 10, 2017 at 18:06:33 from (199.16.223.153):
In Reply to: IH 239 injector Help posted by dale c mi on February 10, 2017 at 17:43:23:
Good chance the trouble is not the injector, white smoke means fuel is getting into the chamber but there's not enough compression heat to burn it. Did you try loosening each injector inlet line nut, taking fuel away while running to see if the smoke clears? Does the blowby tube have "puffs" of air coming out while running? That's a sign there's piston/sleeve/ring trouble. Can be confirmed with a compression check after the injectors are out. My Hydro 84 has the late Bosch bar stock injectors with the single clamp bolt holding them in place. Early engines used the two bolt style Bosch injector. On either type drain the coolant first before pulling them as the brass sleeve they are in MAY come out too. I've had to split the brass sleeve to get out the corroded injector from the sleeve..
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
