Posted by Dr. Walt on February 10, 2017 at 05:41:37 from (12.2.223.66):
In Reply to: key lock posted by caterpillar guy on February 09, 2017 at 20:20:08:
caterpillar guy:
Most column switches work the same, carefully inspect the mounting boss for the key-barrel. You're looking for a very small hole, usually located on the side or bottom of the boss; when you find it, open up a Paperclip and insert it into the hole. When you feel the paperclip hit bottom, gently push it in a little bit further so that you push in the spring-loaded pin in there. With the spring-loaded pin depressed, put the flat blade of a small screwdriver into the key slot and turn the key-barrel counterclockwise until it stops. Now gently pull out the key-barrel. Now, take the key-barrel to your local Lock Smith and have them make a new set of keys for that key-barrel (expensive) OR (cheaper) just buy a NEW key-barrel with keys.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
