Posted by John T on February 08, 2017 at 09:17:59 from (76.4.98.182):
In Reply to: Polarity, am I wrong. posted by David G on February 08, 2017 at 06:51:15:
David, when I was a used tractor dealer and farmer doing a lot of tractor electrical repair on circa 40's through 60's genny and VR equipped tractors, many of which were Delco systems, SOME VR'S WERE CLEARLY LABELED FOR POS GROUND WHILE OTHERS WERE CLEARLY LABELED FOR NEG GROUND AND I BET DELCO DESIGNED AND LABELED THEM AS SUCH FOR A SOUND ENGINEERING REASON. It was my understanding (no warranty) it had to do with the relay contacts and their particular coatings and which contacts used what coating. Also if solid state devices were utilized within (even though still primarily a mechanical VR), its obvious why they required a certain polarity. Then it seems later years I saw some VR's that were suitable for EITHER polarity.
Sooooooooo I may be wrong but its my engineers opinion THERE IS A DIFFERENCE in VR's for use with different polarity. That being said its my best engineering guess that if there's no solid state devices used (like blocking diodes) while a VR may still "work" and the incorrect polarity, it may well last LONGER if the correct polarity VR is used.
That's my story n Ima stickin to it lol BUT NO WARRANTY IT MAY BE WRONG AS RAIN
John T Retired Electrical Engineer NEVER a designer of VR's
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
