For my Poulan I just chuck the appropriate size file in my cordless reversing drill motor. Have it rotate so it's moving metal towards the edge and make a filing motion three or four times while pulling trigger on drill motor. Be consistent with all the teeth and try to keep the angle the same as much as possible. About every third sharpening I take a flat file to the rakers before doing the teeth. I get very good results and it doesn't take much time at all. The wife got me one of those HF cheapies one year. I get okay results with it, but it's nothing to write home about, and it takes three times as long and there's all that fussing around to get it just right. The file and drill motor trick is the way to go.
Now on my Husqvarna it has larger teeth/chain so I do it a bit differently. While I do have some files that would fit, I find it easier to just grab a couple brews and wander on over to my neighbor's. He owns a tree service and has one of those industrial strength sharpeners. He can have that thing done quicker than I can down a beer. Which if you knew how much I like beer you'd realize what a true feat that is. JD
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
