I couldn't get the crud to drain from one of the antiques I bought. I think I finally kept dumping in a little fuel oil, and driving it around to mix it up, so I could get it to flow at all. Even then it took time for it to work its way out! Someone had apparently pumped so much grease in there it was more like grease than oil. I assume the effort was trying to cover up a noisy bearing. It was noisy, but operated just fine for me with gear oil in it. The same tractor (AC B or C), with a hydraulic system, should have 20 or 30 engine oil in the rear end-same as in the engine, depending on the season. Quite a leap from that to grease!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Seeing an Old Friend - by Joe Evans. Dad had a concrete contracting business starting in 1960. One of his first pieces of equipment was a Ferguson TO-35 with a Davis loader. Dad replaced the TO-35 with a MF 202 Workbull, essentially an industrialized Ferguson 35 I am told. Dad bought the 202 new in 1962, and I recall quite clearly going to the dealer with him to sign for it.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.