Posted by rustred on January 30, 2017 at 08:31:23 from (74.214.153.210):
In Reply to: Hand Cranking posted by Johnnykick on January 30, 2017 at 07:56:26:
if its kicking back u have the timing advanced too far. it is firing before the piston reaches top dead centre and is pushing the piston back down. you need to have timing set to spec's. or you will get hurt this way. i always lube where the crank goes in and the pin at the crank end. makes life so much easier. proper technic is to pull up on the crank not push down as that will break your arm if she backfires. that little 100 is nothing much to crank. i have many tractors that i hand crank and not a one will backfire, but i have them tuned with timing set . dont trust someone elses tractor either. a girl stalled her massey 55 at the tractor pulls, so i went to crank it for her. that thing spun backwards due to timing advance. and hurt my hand a bit. left that one alone and they pulled it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
