Roger........are you sphincterly challenged? I went to a Jr College that had a gun smithing school founded by P O Ackerly. I always thought gunnies were nutts. One of 'em had a 50-cal machinegun barrel that he made a rolling block action for it. We'd go east of town and go bunny bumping. Shoot that single shot barrel mounted in a wooden railroad tye (actually a 4X6) with a string on the trigger. Then use a brass welding rod to poke the empty casing out the back end. Made a #ell of a noise and smoke across the arroya. (canyon)
As fer yer carbie; gitt a "hollow-ground" gunsmithing screwdriver (make one by holding the side against a grinding wheel) Then dunk yer carbie in HOT BOILING WATER. The castiron will expand enuff so you kenn un-screw yer BRASS jet. Simple, eh? Iff'n you do what Old suggests, be certain to use EYE PROTECTION.......HTH, the amazing Dell
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
