Posted by Dave H (MI) on January 16, 2017 at 17:30:42 from (50.108.121.223):
Last week I received an email from a fella here on the forum. He had read that I needed some bin jacks. A friend who farmed and sold bins as a side line many years ago had some in his barn he would sell for a reasonable price. So I called the man and arranged to head down to his place outside of Toledo. Very nice man, I had a long conversation with him while we loaded the truck. Let me look at the barn his father had built...nice barn. Talked to me about moving bins. The picture is not great but what is there is 8 good heavy duty bin jacks, a center support jack for the roof collar with two different size tops, steel sectional concrete forms enough to make a circle up to 32', a ratcheting cable lift that fits over the roof hole and can be used to lift a stirator or similar, and three sections of scaffolding for working on the roof from inside the bin. My Spring project just got a lot easier/safer. I don't know the fellas handle who referred me, but I sure do appreciate it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
