|
Tractor Talk Discussion Board |
Re: O/T- lean-to shed roof flashing?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Billy NY on June 10, 2007 at 10:14:57 from (205.188.116.14):
In Reply to: O/T- lean-to shed roof flashing? posted by dds-inc on June 10, 2007 at 09:56:06:
Photos would help, but probably not all that difficult to fasten something similar to reglet like is sometimes used on masonry walls that are pre-existing to an addition and have nothing built into the coursing of brick already. If you were to attach a piece of pre-formed metal, that would receive flashing, you just need to seal the vertical area behind it as it's attached to the T-111 siding, with a good sealant, and make a nice sealant joint on top of it. It would also be nice to have an overhang from the rood above on the main building. Someone else might have a better detail than this, but as long as you return up the vertical area that rises above the roof you joined to the wall with some kind of metal like a reglet or similar, then you have something to tie into from the new roof. The pieces you attach to the existing wall need to be continuous, if they overlap beacuse the dimensions are longer, make sure to seal that joint, and I'd overlap them at least 1'-0" same with the flashing. Under neath this you could also use a material like W.R. Grace Ice & Water Shield, seal the top of the vertical return at the T-111, then place metal flashing as described above. Again, someone else may have a cleaner detail than this, but I'd think something similar would perform nicely.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
